Drew Technologies DashDAQ Series II Manual de Instruções descarregar pdf (Página 19)

GAUGE SETUP & NAVIGATION

NAVIGATING GAUGES:

To access DashDAQ gauges, tap on [Gauges] from the Main Menu. The last gauge layout viewed, or this screen, will be displayed.

Figure 3: Layout with 3 round gauges

To change gauge layouts, tap on the [<<] and [>>] buttons. Two gauge layout examples:

Figure 4: Layout for graphing up to 8 signals

Figure 5: Layout for displaying up to 9 numeric signals

ASSIGN A SIGNAL TO A GAUGE

Before assigning signals to a gauge, make sure the New Vehicle Setup has been completed.

1. Do the New Vehicle Setup for each new vehicle (section 0)

2. Select a gauge layout.

3. Tap on the gauge where the signal will be displayed. This screen will appear:

4. Tap on [Assign Signal].

5. Using the [<] and [>] buttons at the top of the screen and the scroll slider on the right side of the list, go through the available

signals.

6. Select the signal that you would like displayed on the gauge

7. Tap [Save].

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Sem comentários

Drew Technologies DashDAQ Series II Manual de Instruções Página 19