Drew-technologies DASHDAQ-XL Manual do Utilizador descarregar pdf (Página 14)

SET GAUGE MIN/MAX VALUES-OPTIONAL

Tap on the [Low Limit] button to set the bottom value for the signal.

Tap on the [High Limit] button to set the top value for the signal.

1. Tap [Low Limit] or [High Limit] will bring up this screen:

Entering maximum value for a gauge

2. Type in the desired value.

3. To make the value negative tap [+/-].

4. Tap [save]

5. Repeat steps 1-4 to set the signal’s minimum value.

SET GAUGE LOW WARNING / HIGH WARNING-OPTIONAL

You can also create an upper and lower “redline” region on the DashDAQ. The below gauge has a “redline danger zone” between 5000

and 6000 RPM.

To set a High/Low Warning:

1. Tap on the gauge where a High/Low Warning is to be set.

2. On the Assign Signal screen, tap on [High Warning] or [Low Warning].

3. Type in the desired upper or lower warning level number. Tap [+/-] to make the value negative.

4. Tap [Save].

5. Tap [Save] on the Assign Signal screen to go back to the gauges.

Round gauge with a high limit warning

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 46 47

Sem comentários

Drew-technologies DASHDAQ-XL Manual do Utilizador Página 14